GRE 0716 - Page 108

LMIT Parameter Options Description
Delay
Delay Time
Zeromatic
Search Dir
Hit Count
On or Off
Controls whether a Delay is used to wait for reply
traffic after a transmission is received during the
LMIT search.
1-200
Sets the amount of time (in 100 millisecond
intervals) for the wait for reply delay if Delay is On,
e.g., 20=2 seconds.
On or Off
When on, enhances the scanners ability to lock on
to the actual center frequency of a search hit
instead of an adjacent frequency.
Up or Down
Sets search direction used when LMIT object is
active.
Numeric value
Increments each time a transmission is received on
the SWPR object. Global “Hit Counts” must be set
to ON. Press the
Dflt softkey to reset to 0.
0716 User Manual  Page 108