GRE 0716 - Setting the Default Scan List; Deleting Objects

object using the 5-way pushbutton pad. Press FUNC, then L/OUT
to remove permanent lockout from the talkgroup. Press FUNC,
then
CLR to delete the TGRP object from the scanner. Press the
EDIT, then the CURR softkey to edit and save the TGRP object.
Setting the Default Scan List
By default, your scanner will store all new objects, and objects
found during Search, Tune, and Sweeper as mapped to Scan
List 01.
You can easily change the default Scan List to any Scan List you
specify, including the special FAV and SKYWARN Scan Lists.
Press
PGM, then the GLOB softkey, and use the  key to scroll
down until the Dflt ScanList item appears in the middle of
the display. Enter a new Scan List number to use as the default
Scan List. The following numbers are valid:
0: The “not scanned” (ns) Scan List - objects that have no
 Scan List mappings can be found here
1-20:The twenty normal Scan Lists
21: The FAV Scan List
22: The SKYWARN Scan List.
Press
ENT or the Done softkey to store your new default Scan
List value, then press the SAVE softkey to save your changes to
the radios configuration memory.
Deleting Objects
Objects that you no longer need to use can easily be deleted
from the 0716's memory, making room for new objects.
To delete an object, press
PGM, then use the  keys to
navigate to the object you wish to delete. Press
FUNC CLR to
delete the object. The scanner will ask you to confirm the delete
command before removing the object from the scanners
memory. Deletions cannot be un-done.
To delete a TSYS, use the FIND feature to search for the TSYS
by name. Press
PGM, then press the EDIT softkey, then press
the FIND softkey, and use the Standard Text Entry Method to
enter all or part of the TSYS name you wish to delete. Press the
OK softkey to begin searching, and, if necessary, press the NEXT
softkey to continue searching until the desired TSYS is located.
0716 User Manual  Page 64