GLOB Menu Reference
The GLOB menu stores all of the radio-wide settings used by the
scanner. The GLOB menu allows you to “tweak” these settings to
your liking. The default settings will work fine for most users, but
most users will want to use the GLOB menu to personalize the
radio to suit their individual tastes. The active parameter is
always the middle parameter and is indicated by a flashing “:”.
The entire GLOB menu is shown below. Note that some GLOB
parameter changes do not take effect until the GLOB menu is
saved.
HINT: You can restore all GLOB settings to their defaults without affecting
your programmed objects or V-Scanners. Power cycle the radio, then
press
0, then 2 during the welcome message display. Press ENT to
confirm the GLOB parameter reset.
GLOB
Parameter
Options Description
CONTRAST
Owner
Clone Send
Alert Mode
Sound Mode
Key Beeps
Light Mode
Light Area
1-7
Sets LCD contrast. Use keys on 5-way
pushbutton pad.
SEL
Enters sub menu to set Welcome Message text
display.
SEL Press
SEL to send data using clone mode
Both, Tone, Light, Off
Controls the ALERT LED and Audible Alarm
behavior. Both allows the LED and Tone. Tone
allows the audible alarm only. Light allows the LED
only. Off deactivates the ALERT LED and Audible
Alarm feature.
Key or Stlth Controls all radio beeps.
On or Off Controls key beeps.
On, Stlth
Controls the backlight operation. On causes the
backlight to remain on all the time.
Stlth (Steath)
disables the backlight.
Both, LCD, Keybd
Controls what area is illuminated when the
backlight is on.
Both illuminates the LCD and the
keypad,
LCD illuminates the display only. Keybd
(Keyboard) illuminates the keypad only.
0716 User Manual Page 98
To Next Page
Loading...
