Gree GMV-PD160W/NAB-M

36
DC Inverter Multi
VRF Service Manual
DPOUSPM
1 ALL ON
This central control has Sequence On function, that enable conduction to sequence
control to communication modular in interval of 2 seconds, communication modular
controls Sequence On of indoor units (to lower impact to power network).
2 ALL OFF
This central control has Sequence Off function, that enable conduction of sequence
control to communication modular in interval of 2 seconds, communication module
controls Sequence Off of indoor units (to lower impact to power network).
3 TIMER Set and check the time of Timer On and Timer Off of indoor unit and date mode.
4 SWING Set if indoor unit swings
5 SPEED Set fan speeds of High, Medium, Low or Auto for indoor unit
6 MODE Set modes of Cool, Dry, Fan or Heat for indoor unit
7 ON/OFF (2) For controlling units’ on and off.
8
LEFT/RIGHT
UP/DOWN
It works as direction and adjusting under every operation function. Such as: When checking,
it can move to the required indoor unit or communication modular by using this button; when
adjusting time, press LEFT (/RIGHT) to shift “Y/M/D” etc. and press UP (/DOWN) to adjust value
9 CONTROL
Under control mode, press this button after setting state of indoor unit, control
to indoor unit would be conducted by corresponding control mode.
10 GROUP
Press button under checking state to begin information check and set of
grouped indoor unit, grouped information is for select control.
11 TIME Set system time
12 SYSTEM/TEST Begin setting of central control run mode, it is not recommended to be used by users.
13 INDOOR/DOMAIN
Shift display domain and indoor wired air condition control. DOMAIN corresponding to display
on line communication modular, INDOOR corresponding to display on line indoor control.
14 SELECT Select required control or setting object; repress the button to the object is to cancel.
15
CONTROL MODE
Begin control setting mode, and Central Control, Select Control and Single Control can be selected.
Central Control: Control all indoor units under domain by present set state.
Single Control: Control present indoor unit by present set state.
Select Control: Control selected indoor unit by present set state, it also called grouped control
16 CONFIRM &RQ¿UPWKHRSHUDWHGRSHUDWLRQLVHIIHFWLYH
17 CANCEL
Press this button during process of setting function to exit the already made
function setting operation. Such as, if central control mode were selected, press
CANCEL at this time would back to control mode selecting state.