Gree GMV-PD160W/NAB-M

41
DC Inverter Multi
VRF Service Manual
DPOUSPM
(2) Make 4 pieces of wooden or plastic chucks
21
138
19
64
Wall
Wooden chucks or plastic chucks
Fig.7.2.4.2
To be installed in the control cabinet:
0DNHKROHVLQVLGHWKHZDOORIFRQWUROFDELQHWDFFRUGLQJWRWKHIROORZLQJGLPHQVLRQLQWKH¿JXUH
138

64
Fig.7.2.4.3
2) Install the electric box cover on the wall or in the control cabinet.
138
64
GND
Wire holeWire hole
Fig.6.2.4.4
3) Connection of power cord and communication wire
Make the communication wire through the wire hole of the electric box cover and insert it into the
communication port. Make the Power cord through the other wire hole on the electric box cover should be
FRQQHFWHGZLWKWKHZLULQJWHUPLQDORQWKHPDLQERDUGRIFRQWUROOHUDVVKRZQLQWKH¿JXUHEHORZ/FRQQHFWVZLWK
live wire, N connects with neutral wire and ground wire connects to the corresponding position marked on the
electric box. Wire hole can be freely set according to actual condition.
Power cord width connected with wiring terminals shall be in the range of 1.5~2.2mm.
Rated voltage of wiring terminal is 220~240 VAC.
Power frequency is 50/60HZ.