Unit Control
57
3.2.2.12 Weekly Timer
This function will make the unit run with certain modes in certain periods within a week based on the
user’s actual demand.
[Operation Instructions]
1. At the homepage, by pressing the Function key access to the
FUNCTION
page, and then
locate where “
Weekly timer
” is by switching pages, after that, press OK key to go to the
WEEKLY
TIMER
setting page.
2. At the
WEEKLY TIMER
setting page, by the Right/Left key it is able to select the
desired week day and then by the Up/Down key to set this day, “
√”
, “×” or “Holiday”, as
shown in the figure below. When this setting is finished, press OK key to go to this day’s setting
page.
3. At the week day’s setting page, it is allowed to set the running mode (Mode), temperature set
point (WT-HEAT), and water tank temperature (T-Water Tank). The running mode includes “
Heat
”,
“
Cool
”, “
Hot water
”, “
Heat+ hot water
”, “
Cool+ hot water
” (the last three ones are available only when
“Water tank” is set to “With”. There are totally five periods for each day, and each period can be set to
“
√”
or “×”. Besides, it is able to set the “
Start time
” and “
End time
” for each period, as shown in the
figure below.
To Next Page
Loading...
