Unit Control
71
3. 2.4 View
At the view pages, the user is enabled to view the unit’s running state, running parameters, errors,
version of the wired controller etc.
[Operation Instructions]
At the homepage, by pressing the Function key no.3 , it is able to go to the
VIEW
page as
shown in the figure below.
3. 2.4.1 Status View
At the status view pages, the user is enabled to view the unit’s running status, like compressor
On/Off, fan 1 On/Off, water pump On/Off, antifreeze On/Off, defrost On/Off etc.
[Operation Instructions]
1. At the
VIEW
page, select “
Status
” and then press the OK key to go to the
STATUS
page.
2. At the
STATUS
page, it is able to check the status of each component.
Viewable Components
To Next Page
Loading...
