Gree GRS-CQ8.0Pd/NaEK - Parameter Setting (Parameter Set)

Unit Control
68
3.2.3 Parameter Setting (Parameter Set)
3.2.3.1 User Parameter Setting
At the parameter setting pages, each parameter is configurable, like: water out temperature for
cooling, water out temperature for heating, and water tank temperature etc.
[Operation Instructions]
1. At the homepage, it is able to go to the
PARAMETER
page by pressing the Function key no. 2
.
2. At the
Parameter Set
page, by the Left/Right key select the desired option and then
by the Up/Down key increase or decrease the setting value which will be continuously
changed when pressing and holding the key.
3. When the setting is finished, press “
Save
” and a dialog box will pop up, reminding “
Save
settings?
”. If so, press the OK key ; if not press the Cancel key to not save this setting.
[Notes]
①
For those parameter which default value vary by different condition, the value will set to default
when the condition changes.
User Setting
No
.
Full Name
Displayed
Name
Range
Default
1
Water out
temperature for
cooling
WOT-Cool
7~25°C
[With FCU]
18~25°C
45~77°F
[With FCU]
64~77°F
7°C/45°F[With FCU]
18°C/64°F[Without FCU]