Gree Versati II Series - Page 79

76
Air to Water Heat Pump
Service Manual- Versati II Series
MAINTENANCE
7) Remove the motor
●
Loosen the screws fixing the motor
support.
●
Remove the motor support. Loosen the
wire of motor, and pull it through the hole.
Remove the motor. [See Fig� 10]
Fig.10
8) Remove the 4-way valve
●
Loosen the screws fixing the coil of
4-way valve.
●
Remove the coil of 4-way valve.
●
Unsolder the tubes connected to the
4-way valve.
●
Remove the 4-way valve.[See Fig.11]
Note: When welding, the valve should be
covered by wet cloth in order to avoid the
high temp. damage.
Fig.11