Greenlee 555C - Troubleshooting Common Problems

Greenlee / A Textron Company 27 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
555C Electric Bender Classic
Troubleshooting
Problem Probable Cause Possible Remedy
Check that switch is on.
Bender will not operate. No voltage. Check supply voltage circuit operation.
Unusual conduit characteristics. Bend smaller angle to compensate.
Bends are overbent a few
degrees.
Too much squeeze on 1-1/2" or 2"
EMT or IMC conduit.
Back squeeze off per adjustment
instructions.
Unusual conduit characteristics. Bend larger angle to compensate.
Bends are underbent a few
degrees.
Too little squeeze on 1-1/2" or 2"
EMT or IMC conduit.
Increase squeeze per adjustment
instructions.