Greenlee 854 - Product Introduction and Safety Basics; General Safety Importance

854 Quad Bender
Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
2
All specications are nominal and may change as design
improvements occur. Greenlee Textron Inc. shall not be liable for
damages resulting from misapplication or misuse of its products.
Loctite is a registered trademark of Loctite Corporation.
KEEP THIS MANUAL
Table of Contents
Description .................................................................... 2
Safety ............................................................................ 2
Purpose ......................................................................... 2
Important Safety Information .....................................3–4
Grounding Instructions .................................................. 5
Identication .................................................................. 6
Specications ................................................................ 6
Transportation and Setup .............................................. 7
Operation ..................................................................8–10
Illustrated Bending Glossary ....................................... 11
Bending Instructions ..............................................12–13
Special Bending Information ..................................14–21
Español ........................................................................ 23
Français ....................................................................... 45
Description
The Greenlee 854 Quad Bender is an electric-powered
conduit and pipe bender, intended to make up to 90°
bends in 1/2" to 2" conduit and pipe. It is capable of
bending the following:
EMT
IMC
Rigid Aluminum
Rigid Steel
40 Mil PVC-Coated Rigid Steel (requires PVC
Shoe Group 01700, purchased separately)
Schedule 40 Pipe
Note: This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the Federal Communications
Commission rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accor-
dance with the instruction manual, may cause harmful
interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to
correct the interference at his own expense.
Do not make any modifications to this device.
Unauthorized changes or modifications will void the
user’s authority to operate this device under United
States federal law.
•
•
•
•
•
•
Safety
Safety is essential in the use and maintenance of
Greenlee tools and equipment. This instruction manual
and any markings on the tool provide information for
avoiding hazards and unsafe practices related to the
use of this tool. Observe all of the safety information
provided.
Purpose of this Manual
This manual is intended to familiarize personnel with the
safe operation procedures for the following tool:
854 (03106) Serial Number AKM
Keep this manual available to all personnel.
Replacement manuals are available upon request at no
charge at www.greenlee.com.
Other Publications
Service Bulletin: 52033654