Greenlee 910FS - Page 8

910FS Splicer
Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
8
• Do not store tool in areas of extremely high temperature and humidity.
• Do not touch protection sleeve or tube heater during or immediately after heating.
These surfaces are very hot and touching them may result in burns.
• Do not place tool in an unstable or unbalanced position. Tool may shift or lose
balance, causing unit to fall.
• This tool is precision adjusted and aligned. Do not allow unit to receive a strong
shock or impact. Use supplied carrying case for transportation and storage.
Carrying case protects tool from damage, moisture, vibration, and shock.
Failure to observe these precautions may result in injury and may damage the unit.
Follow these instructions for handling electrodes:
• Use only specied electrodes.
• Set new electrodes in correct position.
• Replace electrodes as a pair.
Failure to observe this precaution may cause abnormal arc discharge, which may
result in equipment damage or degradation in splicing performance.
• Do not use any chemical other than pure alcohol (99% or greater) to clean the
objective lens, V-groove, mirror, LCD monitor, etc. Use of other chemicals may
cause blurring, discoloration, damage, or deterioration.
• This tool requires no lubrication. Oil or grease may degrade the splicing
performance and damage the splicer.
• This equipment must be repaired or adjusted by a qualied technician or engineer.
Incorrect repair may cause re or electric shock. Contact Greenlee service center
for repair.
Failure to observe these precautions may result in injury and may damage the unit.
Important Safety Information