Need help?Do you have a question about the Greenlee 910FS and is the answer not in the manual?
General| Brand | Greenlee |
|---|---|
| Model | 910FS |
| Category | Computer Hardware |
| Language | English |
Explains the Greenlee Communications 910FS Optical Fiber Fusion Splicer's purpose and technology.
Informs personnel about safe operation and maintenance of the 910FS Optical Fiber Fusion Splicer.
Use the unit for its intended purpose; do not use on live fibers.
Specifies operating conditions for humidity and altitude.
Verify line voltage and fuse before applying power.
Do not operate in the presence of flammable gases or fumes.
Do not remove the cover as it contains no user-serviceable parts.
Identifies the main parts of the 910FS fusion splicer with labels.
Provides a top-down view of the fusion splicer with labeled components.
Covers installing, removing, and checking the battery capacity of the splicer.
Explains SM and AUTO splice modes, including automatic arc calibration.
Details stripping, cleaning, cleaving, and loading fiber into the splicer.
Outlines the standard operating procedure for performing a splice, including checks and loss estimation.
Details heating the protection sleeve and using the cooling tray after splicing.
Discusses using splice-on connectors with the 910FS fusion splicer.
Explains how to use the carrying case as a work table for the splicer.
Information on how to upgrade the 910FS software via www.greenlee.com.
Covers selecting and editing splice modes within the S-Mode menu.
Details various parameters available for editing in splice modes.
Covers selecting and editing heater modes within the H-Mode menu.
Details various parameters available for editing in heater modes.
Explains how to perform arc calibration within the Maintenance menu.
Details how to clean the splicer electrodes using an electrode polisher and IPA.
Explains manual motor control and automatic motor position calibration.
Covers adjusting the screen display and replacing the electrodes.
Details stabilizing electrodes and configuring splice settings.
Allows configuration of splice settings like auto start, display options, and limits.
Enables displaying, exporting, and clearing stored splice results.
Covers formatting memory and clearing the arc count for data management.
Displays total fusion count, software version, and serial number.
Allows selection of the user interface language.
Configures audible beeps and display orientation for the splicer.
Adjusts automatic power saving and LCD screen brightness settings.
Covers setting date/time, loading defaults, sensor values, and password protection.
Lists the technical specifications of the 910FS fusion splicer, including fiber types, loss, and environmental limits.
Identifies common causes and remedies for high splice loss.
Addresses issues with the fiber cleaver not functioning correctly, such as coating removal.
Lists common error messages displayed by the splicer and their corresponding solutions.
Details reasons and solutions for high estimated splice loss.
Safety precautions and general guidelines for cleaning the 910FS and 910CL.
Step-by-step instructions for cleaning the splicer's V-grooves and fiber clamps.
Instructions for cleaning the wind protector mirrors and objective lenses.
Details cleaning electrodes, general splicer areas, and the 910CL fiber cleaver.
General precautions for practicing fusion splicing with the 910FS.
Procedure for checking splice quality using a power meter and test fiber.
Procedure for testing splice-on connectors using a similar setup and test patch cord.
Identifies connector components and details cable preparation steps.
Steps for installing the splice-on connector into the 910FS fusion splicer.
Outlines the warranty terms and conditions for Greenlee products, including repair information.
To Next Page