GREMSY T7 - Filter Settings

To Next Page

To Previous Page

SOFTWARE & TUNING 40

FILTER

The purpose of the lters is to eliminate noise and vibration due to structural

resonances in the camera, lens, or gimbal.

Setting the lters too high or too low can cause signal disturbances that can

reduce the overall stabilization.

GYRO FILTER

Denes the strength of the lter applied to Gyro sensor output. If the gimbal has

oscillations that cannot be corrected by adjusting stiffness settings, the Gyro

Filter is used to further tune the gimbal and remove the oscillation.

OUTPUT FILTER

Denes the strength of the lter applied to motors output. If the gimbal has

oscillations that cannot be corrected by adjusting stiffness settings, the Output

Filter is used to further tune the gimbal and remove the oscillation.

1. If the gimbal is vibrating at a high frequency after tuning, increase the lter

values.

2. If the gimbal is oscillating or rocking at a low frequency after tuning, decrease

the lter values.

DEFAULT VALUES

Gyro Filter

Output Filter