REMOTE CONTROL 51
CHANNEL SETTING There are 6 channels to assign: MODE, TILT, ROLL, PAN, TILT SPEED, PAN SPEED
.
Assign MODE channel rst then follow the order above because MODE channel
is used to change operating modes of the gimbal and should be assigned to a
3-position switch as follows:
Switch at high position: FOLLOW MODE , MOTORS ON
Switch at middle position: LOCK MODE , MOTORS ON
Switch at low position: MOTORS OFF
TILT and PAN channel should be in speed mode and ROLL channel in angle mode.
TILT SPEED or PAN SPEED could be assigned to the same channel and should be
assigned to throttle stick, dial, or other non-centering control on the transmitter.
Below is an example of channel assignment to the Futaba T8FG.
CHANNEL CONTROL NOTE
MODE
TILT
ROLL
PAN
TILT SPEED
PAN SPEED
5
2
4
1
3
6
SC
J2
T4
J1
J3
RD
3 positions switch
Speed mode
Angle mode
Speed mode
To Next Page
Loading...