SOFTWARE & TUNING 41
EXPERT / ADVANCED
SETTINGS
There are some expert parameters that normally do not need to be adjusted.
Leave these parameters at default settings unless they are required for
troubleshooting.
If “Auto power adjustment” is enabled, “Hold strength” will be the minimum power
level required for the corresponding axis. The controller will automatically adjust
power level from minimum to maximum level depending on the displacement
between current angle and commanded angle.
If “Auto power adjustment” is not selected “Hold strength” will be constant power
level provided to the corresponding axis and should be adjusted manually. This
option is only recommended for advanced users.
For heavy cameras, it’s suggested to increase hold strength for each
axis around 10% than the default value. If “Auto power adjustment” is
not selected “Hold strength” will be xed power level provided to the
corresponding axis and should be adjusted manually. This option is only
recommended for advanced users.
NOTE
HOLD STRENGTH
To Next Page
Loading...