GREMSY T7 - Rotation Limit; Up Limit; Down Limit; Window

SOFTWARE & TUNING 45
ROTATION LIMIT
UP LIMIT
DOWN LIMIT
WINDOW
Travel of Tilt and Roll axis can be limited using UP LIMIT and DOWN LIMIT. The
Pan axis keeps the ability to pan 360 degrees itself.
Set the up limit for Tilt or Roll axis (in 1 degree unit). The default values are -90 for
Tilt and -45 for Roll.
Set the down limit for Tilt or Roll axis (in 1 degree unit). The default values are 90
for Tilt and 45 for Roll.
Set the Roll offset (in 0.1 degree unit) is only applicable when there is no remote
control signal since remote control will override the roll angle. This is useful to
ne trim the horizon. The default value is 0.