TROUBLESHOOTING 56
PROBLEM
Status LED is blinking red
Status LED is solid red during
startup
Status LED is solid red during
operation
Status LED is solid white after
start up
Gremsy T7 has oscillation in
one or more axes
POSSIBLE CAUSES
Low battery
Camera is not balanced well or
not installed
IMU cable is loose
Tilt motor cable or encoder
cable is loose
Roll motor cable or encoder
cable is loose
Pan motor cable or encoder
cable is loose
IMU sensor cable is loose
Excessive gyro drift
Stiffness setting is too high
Thumbscrew/top bar nut is not
tightened
Camera mounting is not stiff
enough
Filters settings are incorrect:
Gyro and output lter should
only be changed if other
methods of reducing oscillation
have failed
SOLUTION
Recharge battery
Check camera balancing
Check in software for IMU sensor error, re-
seat IMU sensor connector
Check in software for Tilt error, re-seat tilt
motor connector and encoder connector
Check in software for Roll error, re-connect
roll motor connector and encoder cable
Check in software for Pan error, re-connect
pan motor connector and encoder cable
Re-seat IMU sensor connector
Re-calibrate
Reduce stiffness
Check tightening
Check camera mounting
Please read more in manual about Gyro lter
and output lter (Advanced settings)
To Next Page
Loading...