-10-
Model G0505 (Mfg. since 4/04)
Wear safety glasses dur-
ing the entire setup pro-
cess!
This machine presents
serious injury hazards
to untrained users. Read
through this entire manu-
al to become familiar with
the controls and opera-
tions before starting the
machine!
SECTION 3: SETUP
Your machine was carefully packaged for safe
transportation. Remove the packaging materials
from around your machine and inspect it. If you
discover the machine is damaged, please imme-
diately call Customer Service at (570) 546-9663
for advice.
Save the containers and all packing materials for
possible inspection by the carrier or its agent.
Otherwise, filing a freight claim can be difficult.
When you are completely satisfied with the condi-
tion of your shipment, inventory the contents.
Unpacking
This machine and its com-
ponents are very heavy.
Get lifting help to move
heavy items.
Inventory
The following is a description of the main compo-
nents shipped with your machine. Lay the compo-
nents out to inventory them.
Note: If you can't find an item on this list, check
the mounting location on the machine or examine
the packaging materials carefully. Occasionally
we pre-install certain components for shipping
purposes.
Inventory: (Figure 4) Qty
A. Chip Deflector ............................................. 1
B. Knife Gauge ............................................... 1
C. Lock Washer 6mm ..................................... 1
D. Cap Screw M6-1 x 20 ................................. 1
E. Hex Wrench 5mm ....................................... 1
F. Double-End Wrench 8mm .......................... 1
G. Cutterhead Elevation Crank ....................... 1
H. Rubber Machine Feet ................................. 4
SUFFOCATION HAZARD!
Immediately discard all plas-
tic bags and packing materi-
als to eliminate choking/suf-
focation hazards for children
and animals.
Figure 4. Model G0505 inventory.
A
B
E
D
C
F
G
H
To Next Page
Loading...
Need help?
General
