Model G0781 (Mfd. Since 2/15)
-13-
Inventory
Figure 4. Inventory included with machine.
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
K
A
C
D
E
G
B
I
J
L
M
F
H
N
O
P
Small Item Inventory (Figure 4) Qty
A. Toolbox ....................................................... 1
B. Spanner Wrench 38–42 Hook Type ........... 1
C. Open-End Wrench 36mm .......................... 1
D. Spare Fuse ................................................. 1
E. Spindle Pin ................................................. 1
F. Drawbar ...................................................... 1
G. Drill Chuck & Arbor ..................................... 1
H. Open-End Wrench 8/10mm ........................ 1
I. Open-End Wrench 13/16mm ...................... 1
J. Drill Chuck Key ........................................... 1
K. Bottle for Oil ............................................... 1
L. Hex Wrench 2, 2.5, 3, 4, 5, 6, 8mm .....1 Ea.
M. T-Slot Nuts
1
⁄2" x M8-1.25 ........................... 4
N. Studs M8-1.25 x 45 .................................... 4
O. Hex Nuts M8-1.25 ....................................... 4
P. Handwheel Handles w/Screws ................... 3
To Next Page
Loading...
Need help?
General
