Grizzly G0785 - Inventory

Model G0785 (Mfd. Since 3/15)
-13-
Box 1: Qty
A. Wall Bracket ............................................... 1
B. Filter Cleaning Handle ................................ 1
C. Motor Mounting Plate ................................. 1
D. Open-End Wrench 10 x 12mm ................... 1
E. Bag Clamp .................................................. 1
F. Impeller Housing & Fan/Motor Assembly ... 1
Hardware and Bags (Not Shown)
• Flange Bolts
1
⁄4-20 x
1
⁄2" ............................. 4
• Flange Bolts
1
⁄4-20 x
3
⁄4" .............................. 6
• Dust Collection Bag .................................... 1
Box 2: Qty
G. Canister Filter ............................................. 1
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Figure 5. Box 1 inventory.
C
D
E
B
A
F
Figure 6. Box 2 inventory.
G