-20-
Model G0785 (Mfd. Since 3/15)
SECTION 4: OPERATIONS
General
Operating your Model G0785 is simple and
straightforward. Position the machine near the
dust collector where it will not interfere with the
workpiece being processed, connect the duct,
connect the ducting ground, and you are ready
to begin.
Keep in mind that the dust collector is intended for
single machine use and is not designed to draw
dust through long runs and multiple ports simul-
taneously. We do not recommend using ducting
longer than 10 feet. Otherwise, dust collection
efficiency will be greatly reduced.
Do NOT put hands or
small objects near inlet
openings during opera-
tion. Objects sucked
into the inlet will hit the
impeller blade. Failure to
heed this warning could
result in personal injury
or property damage.
When the dust collector is not in use, unplug the
power cord from the power source. Place the
cord away from potential damage sources, such
as high traffic areas, sharp objects, heat sources,
harsh chemicals, water, damp areas, etc.
Machine Storage
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
Eye injuries, respiratory problems, or hear-
ing loss can occur while operating this
tool. Wear personal protective equipment to
reduce your risk from these hazards.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
To Next Page
Loading...
