G0890/G0891 (Mfd. Since 06/19)
-21-
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting
table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the STOP/reset button safety feature functions
properly.
To test run machine:
1.
Clear all setup tools and loose objects away
from machine.
2.
Push STOP button in.
3.
Connect machine to power supply.
4. Twist STOP button clockwise until it springs
out (see Figure 15). This resets the switch so
the machine can start.
Figure 15. Resetting the switch.
5. Press green START button to turn machine
ON. Verify motor starts up and runs smoothly
without any unusual problems or noises.
6.
Press STOP button to turn machine OFF.
7.
WITHOUT resetting STOP button, try to start
machine by pressing the START button. The
machine should not start.
— If the machine does not start, the STOP
button safety feature is working correctly.
Congratulations! Test Run is complete.
— If the machine does start with the STOP
button pushed in, immediately disconnect
power to the machine. The STOP button
safety feature is not working correctly and
must be replaced before further using the
machine. Call Tech Support for help.
To Next Page
Loading...
Need help?
General
