Grizzly G0948 - Inventory

-14-
Model G0948 (Mfd. Since 08/21)
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Inventory (Figure 8) Qty
A. Bandsaw ..................................................... 1
B.
Rip Fence Assembly .................................. 1
C.
Miter Gauge ................................................ 1
D.
Table w/Insert ............................................. 1
E.
Fence Rail .................................................. 1
F. Wing Bolts M8-1.25 x 18 ............................ 4
G.
Push Stick .................................................. 1
H.
Open-End Wrench 10 x 13mm ................... 1
I.
Hex Wrenches 3, 4, 5, 6mm .................1 Ea.
J.
Rubber Feet ............................................... 4
K.
Stand Braces (Long) .................................. 2
L.
Stand Braces (Short) .................................. 2
M.
Stand Legs ................................................. 4
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Figure 8. Inventory.
C
E
D
B
A
F
G
H
I
J
K
L
M
Hardware (Figure 9) Qty
N. Carriage Bolts M8-1.25 x 16 ..................... 16
O.
Flat Washers 8mm ................................... 16
P.
Hex Nuts M8-1.25 ..................................... 16
Figure 9. Hardware.
N
O
P