Grizzly G1014Z - G1014 ZX Cabinet Assembly and Sanding Unit Assembly



9.Optional        
Figure 20


Figure 20.
G1014ZX Cabinet
Assembly
To assemble the G1014ZX cabinet:
1. 

2. 



        

3. 



Figure 21
Figure 21.
4. 

5.Optional
Figure 22

Sanding Unit
Assembly
To assemble the sanding unit:
1.         



Note: To access the top mounting holes
inside the G1014ZX cabinet stand, open the
front door.
Tip: Insert the end of the included 4mm hex
wrench through the mounting holes in the
sanding unit and the stand or cabinet, then
jiggle the wrench back and forth to align the
mounting holes.
Figure 22.