Grizzly G1014Z - Tracking Belt; To Track the Belt; Changing Sanding Disc; To Change the Sanding Disc



Changing Sanding
Disc


AccessoriesPage 41
To change the sanding disc:
1. 
2. 
3. 
      

4.      

      CAUTION: Follow
the manufacturer's safety recommendations
when using acetone or lacquer thinner.
5. 


6.       


 NoteThe tracking control knob is very sen-
sitive; adjust it carefully in small increments.
Turning the knob clockwise moves the belt
toward the front of the sander.
6. 
Figure 78


Tracking Belt


To track the belt:
1.       
Pre-Tracking Belt Page 27
2. 


3. 

4.        

5. ON
Figure 78

Figure45Page
27