Grizzly G1014Z - Machine Operation



  
Machine vibrates
excessively.
      

 
 
 
 
        

       

 

 
 
 Page 39
        

Sanded surface not
square.
 
 
 

 Page
49
 Page 27
    
Page 37
Deep sanding
grooves or scars in
workpiece.
       

 
 
 
 
 
 
        

Grains rub off the
belt or disc easily.
       

      

  

 
Sanding surfaces
clog quickly or burn.
 
      

 
 


Burn marks on
workpiece.
 
 
 
 
 
 
Glazed sanding sur-
faces.
 
 
 
 


Workpiece frequent-
ly gets pulled out of
your hand.
      

 
 
 
  
 
 
 Page 48
Machine Operation