Disc Sanding
To use the sanding disc:
1.
2.
3. ON
4.
5.
Figures 60–63
Figure 61.
Always keep the workpiece on the left side of
the wheel that rotates down toward the work
table. This will keep the workpiece from fly-
ing out of your hands due to kickback.
To reduce the risk of your fingers getting
trapped between the work table and sand-
ing disc, make sure the table is approxi-
mately
1
⁄16" away from the sanding disc.
Figure 62.
Note: To prevent burning the workpiece and over-
loading the sanding disc, move the workpiece
slowly back and forth from the left side of the
sanding disc to the center.
Figure 63.
Figure 60.
To Next Page
Loading...
Need help?
General
