Serious personal injury could occur if you
connect the machine to power before com-
pleting the setup process. DO NOT connect
the machine to the power until instructed
later in this manual.
110/220V Operation
SECTION 2: CIRCUIT REQUIREMENTS
Full Load Amperage Draw
Power Supply Circuit Requirements
If you are unsure about
the wiring codes in your area or you plan to
connect your machine to a shared circuit, con-
sult a qualified electrician.
Power Connection Device
Figure 2
Extension Cords
Electrocution or fire could
result if machine is not
grounded and installed in
compliance with electrical
codes. Compliance MUST
be verified by a qualified
electrician!
Grounding Prong is
Longest of the Three
Prongs
Current
Carrying Prongs
Grounded
Outlet
Figure 2.
NOTICE
The Model G1071 is prewired for 110V oper-
ation. If you plan to operate your machine
at 220V, the motor must be rewired (see
Page 29).
To Next Page
Loading...
Need help?
General
