Grizzly G1071 - Sanding Sleeves



Sanding Sleeves
       



          
     

To change the sanding sleeve on spindles
larger than
5
⁄8":
1. 
2.         
Figure 23
        

Figure 23. Removing sanding sleeve.
NOTICE
Monitor the wear on the sanding sleeves.
The upper portion of the sanding sleeve
often gets very little use. If this is the case,
flip the sanding sleeve over and re-install.
This allows maximum use of the sleeve.
Worn sanding sleeves will not efficiently
remove material and can burn the wood.
3. 
4.  Steps 12    

3. 

4.  Steps 12    

To change the sanding sleeve on spindles
5
⁄8"
and smaller:
1. 
2. 
Figure 24
Figure 24. Retainer nut set screw.