Grizzly G1071 - Table Inserts



Table Inserts

       



NOTICE
lways use the table insert with the small-
est opening that still allows at least
1
⁄8"
clearance around the spindle.
To install the table insert:
1. DISCONNECT SANDER FROM POWER!
2.        

3.       
        
Figure 25
Note: The insert is fitted with pins that allow
it to fit into the table in only one position. This
ensures the table insert will not make con-
tact with the spindle even when the table is
tilted.
4.       Figure 26


Figure 25. Table insert.
Figure 26. Adjusting table insert.