Grizzly G7948 - Setup Procedures

Model G7947/G7948 (Mfd. Since 01/21)
-15-
SECTION 3: SETUP
This machine presents
serious injury hazards
to untrained users. Read
through this entire manu-
al to become familiar with
the controls and opera-
tions before starting the
machine!
Wear safety glasses during
the entire setup process!
HEAVY LIFT!
Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this risk,
get help from other people
and use a forklift (or other
lifting equipment) rated for
weight of this machine.
Items Needed Qty
Safety Glasses (Per Person) ............................. 1
Open-End Wrench 18mm
.................................. 1
Plumb Bob
......................................................... 1
Additional People
.............................................. 2
Rubber Mallet
.................................................... 1
60W Light Bulb (120V operation only)
............... 1
Permanent Marker
............................................. 1
Cleaner/Degreaser (Page 17)
........... As Needed
Needed for Setup
The following items are needed, but not included,
for the setup/assembly of this machine.
This machine was carefully packaged for safe
transport. When unpacking, separate all enclosed
items from packaging materials and inspect them
for shipping damage.
If items are damaged
,
please
call us immediately at (570) 546-9663.
IMPORTANT:
Save all packaging materials until
you are completely satisfied with the machine and
have resolved any issues between Grizzly or the
shipping agent. You MUST have the original pack-
aging to file a freight claim. It is also extremely
helpful if you need to return your machine later.
Unpacking