1174830.doc
Inverter Parameters
Mitsubishi D-700
Pr 79 Operation mode
1 keypad only enabled
2 external operation only
3 freq set via keypad, run via external signal
4 freq set via external signal, run via keypad
To set parameters
press PU/EXT button until PU indicator light is on
press MODE button until display reads P 0
turn dial until the desired parameter number is displayed
press SET button to access parameter value
turn dial until desired value is displayed
press SET button to store parameter value
when complete, turn dial back to parameter #0 and press MODE button
If parameter # 79 has been set to 2 and additional changes need to be made,
change value back to 0, then press PU/EXT button until PU indicator light
is on, then change parameters.
To Next Page
Loading...