183
GB
Use a soft brush or plastic scraper to
clean off grass and ensure a good
cutting result. Regular cleaning also
reduces noise and vibrations.
• Check that the blade shield can rotate
freely.
• Check that the blades can rotate
freely.
• Check that the front wheel can turn
and rotate freely.
Important! Regular cleaning is essential
for the robot to work properly! Make
sure you follow the cleaning advice
above – and do it often. Grass easily
settles everywhere and can affect the
robot’s sensors and functionality.
Problems caused by lack of cleaning are
not covered by the warranty.
Cleaning the charging station.
Just as the robot needs to be cleaned
regularly, it is a good idea to clean the
charging station at the same time.
Remove grass and soil from the drive
plate. Cut down any grass growing
around the charging station. Use
manual grass shears.
Every 2 months or so, the charging
contacts on the charging station
and the robot should be checked
and cleaned if necessary. Use fine
sandpaper or steel wool to remove any
rust or oxidation on the charging plugs.
Blades
It is recommended that you replace
all blades and screws (at the same
time) after each season to ensure a
good cutting result. (keep an eye on
the blades and change more often
if necessary). The blades are easy
to change. All you need is a Phillips
screwdriver (switch off the robot before
working with the blades). Unscrew the
screw and remove any dirt and grass
debris from the blade disc. Replace the
blades with new ones and replace the
screws at the same time. Use the extra
blades and screws supplied. Make sure
the blade screws are tightened properly.
Note: All 3 blades must be changed at
the same time to avoid imbalance.
Important: Check the blade screws
when turning the blades. As the blade’s
rotations cut into the screw, it is
necessary to change the screws at the
same time as the blades.
Use original blades only.
To Next Page
Loading...
