182
Attaching the cover
Place the cover on top of the robotic
lawnmower. Look through the hole
above the display and make sure that
the holes in both back corners align
with the 2 pegs on the robot.
Push the cover firmly onto the pegs
(one at a time) by pressing on the cover
just above the pegs.
Repeat the process for the 2 pegs at the
front of the robot (one at a time)
Transporting and moving the robot
Use the carrying handle under the
robot's rear to carry the robot.
Never carry it by the edge of the cover,
as the top cover may come off and the
robot could fall to the ground.
It is recommended that robot
lawnmowers are transported over long
distances in their original packaging.
It is also recommended to store the
robot in its original packaging over the
winter.
When the robot needs to be moved
away from the cutting area or adjusted,
the large red STOP button must be
activated (see picture).
When the STOP button is activated, the
robot must be switched off. Press and
hold the OFF button until the display
turns off.
CLEANING AND REPLACEMENT OF
PARTS
It is important to keep your robotic
lawnmower clean to prolong its
lifespan.
The robot will be able to handle slopes
more easily if the wheels are clean and
in good working order. The cutting
result will also be much better if the
blades are sharp and can rotate freely
(always switch off the robot completely
when working with the blades).
Cleaning the plastic guards
To protect the electronics and battery
of the robotic lawnmower, do not rinse
the robot with a high-pressure washer.
It is recommended that you use a soft
brush to remove grass and other debris.
If necessary, use a water sprayer or
damp cloth to dissolve dirt.
Cleaning the underside
Wear work gloves for safety! At least
once a month, you will need to
clean the underside of the robotic
lawnmower, especially the blades.
Remember to start by switching off the
robot.
Lay the robot on its side on a soft
surface (e.g. lawn) to avoid scratching
the lawnmower deck.
To Next Page
Loading...
