> Ensure all connectors a re sealed and secure during operation.
> Although designed to meet all safety requirements, some
parts and surfaces of inverter are still hot during operation.
To reduce the risk of injury, do not touch the heatsinkatthe-
backofthe PV- inverter or nearby surfaces while inverter is
operating.
> Incorrect sizing of the PV panels may result in voltages being
present which could destroy the inverter. The inverter display
will read the error message "PV Voltage High!"
> All operations regarding transport, installation and start -up,
including maintenance must be operated by qualified,
trained personnel and in compliance with all prevailing
codes and regulations.
> When the inverter is disconnected from the grid, please be
careful because some components can retain enough charge
to create a shock hazard. In order to minimize the occur-
rence of this situation,observe all corresponding safety sym-
bols and marks in this manual.
> Under special circumstances, the inverter may be subject to
electromagnetic interference from surrounding equipment.
At this time, the user is obliged to take correct measures to
reduce the interference from surrounding equipment to the
inverter.
> Do not stay close to the inverter less than 20cm atanytime.
To Next Page
Loading...
