5 Installation
5.1 Basic installation requirements
> The wall on which the inverter is mounted must be sturdy and can withstand
the weight of the inverter for a long time (refer to the specifications in Chapter 1
2 for the weight of the inverter);
> The installation location must match the size of the inverter;
> Do not install the inverter on a building constructed of flammable or heat -
resistant materials;
> Install the inverter in an eye-view orientation to facilitate inspection of the
OLED displayand maintenance work;
> The machine's degree of protection is IP66 and can be installed indoors and
outdoors;
> It is not recommended to expose the inverter directly to strong sunlight to
prevent overheating and cause power derating;
> The humidity of the installation environment should be between 0 and 90%;
> The ambient temperature around the inverter should be between -25 °C ~60°C;
> The inverter can be mounted on a plane that is tilted verticaIly or backwards.
Please refer to the following figure:
> In order to ensure the normal operation of the machine and the convenience of
personnel operation, please pay attention to provide sufficient clea rance for the
inverter. Please refer to the figure below:
To Next Page
Loading...
