Growatt MIN 2500TL-XH - 6.3 Connecting the second protective conductor; 6.4 Connecting the PV Array; 6.4.1 Conditions for PV Array

29
MIN 4600 TL-XH
5.2 mm² 10AWG
28m
26m
24m
6.3 Connecting the second protective conductor
In some installation countries, a second protective conductor is required to prevent a touch current
in the event of a malfunction in the original protective conductor.For installation countries falling
within the scope of validity of the IEC standard 62109, you must install the protective conductor
on the AC terminal with a conductor cross-section of at least 10 mm²Cu.Or Install a second
protective conductor on the earth terminal with the same cross-section as the original
protective conductor on the AC terminal. This prevents touch current if the original protective
conductor fails.
6.4 Connecting the PV Array
6.4.1 Conditions for PV Array
The MIN TL-XH single-phase inverter has 2 independent PV input : PV1 & PV2
Notice that the connectors are in paired (male and female connectors). The connectors
for PV arrays and inverters are Helios H4-R/VP-D4/MC4 connectors;