17
18
Step 1: Remove the locking nut and waterproofing bolt.
Step 2: Route the AC output power cable through the conduit and then the fitting of the
pipe.
Step 3: Connect the AC output power cable to the terminal block.
Step 4: Secure the fitting to the conduit.
Step 5: Check that the cables are connected correctly and securely. Then take
appropriate measures to ensure that the pipe conduit and fittings are secured reliably,
and seal the cable holes.
EPS output terminal connection steps as follow:
Step 1: Remove the locking nut and waterproofing bolt.
Step 2: Route the EPS output power cable through the conduit and then the fitting of
the pipe.
Step 3: Connect the EPS output power cable to the terminal block.
Step 4: Secure the fitting to the conduit.
Step 5: Check that the cables are connected correctly and securely. Then take
appropriate measures to ensure that the pipe conduit and fittings are secured reliably,
and seal the cable holes.
AC output terminal connection steps as follow:
17 mm
L 1
L 2
P E
N
17 mm
E -L 1
E -L 2
P E
To Next Page
Loading...
