33
34
Note:
1. “Down” control command (if pushing “up” button, command will go back).
2. Workmode depend on the situation. If SPH is normal state, it will show “normal”. If
SPH is standby state, it will show as “standby” etc.
3. Some special definitions are explained, for example: Vb means the voltage of
battery. Cb means the capacity of lithium battery (only lithium battery shows this
data). Pm means the monitor power of user.
6.3.4 Work mode set up
Keep pressing “enter ”for 3S, you can enter set up surface, in the set up surface you
need hold button Enter or ESC 1S for selection, you can see the surface as showing
below.
Basic Parameter
WorkMode
WorkMode
Configuration
WorkMode
MODE Change
WorkMode
Priority
WorkMode
Offgrid
Press “enter” key more than
3 seconds into setup mode
Press “down” key
to the next item
Press “enter” key more
than 1 seconds to make sure
Default Set
WorkMode
Backup
WorkMode
ExportLimit
WorkMode
1. Under the Basic Para, you can see the setup options below after pressing Enter for
In the basic Parameter, you can set language (English default), system time, Rated
voltage (default is 240V), lead-acid cell charging voltage (default is 58V), discharge
low voltage (default is 48V) and lead-acid constant current (default is 75A).
2. Under the Off gird mode, you can see the setup options below after pressing Enter
for 1S:
In the Off grid you can set EPS, including enable or disable (default is enable), AC
voltage(default is 240V) and frequency (default site 60HZ).
WorkMode
Off grid
WorkMode
WorkMode
WorkMode
Off grid: Enable
Disable
ACVolt: 240 V
208
230
WorkMode
AC Freq: 60 Hz
50
Press “enter” key more
than 1 seconds to make sure
Press “down” key
to the next item
Press “enter” key more
than 1 seconds to make sure
EPS setup
WorkMode
WorkMode
Language
WorkMode
English
WorkMode
System time
WorkMode
xxD/xxM/xxxxY
WorkMode
Lead-acid CV
WorkMode
58.0 V
WorkMode
Lead-acid CC
WorkMode
75 A
Press “enter” key more
than 1 seconds to make sure
Press “down” key
to the next item
Press “enter” key more
than 1 seconds to make sure
Range from 55 to 60V,
and the accuracy is 0.1V
Range from 0 to 75A, and
the accuracy is 0.1A
WorkMode
Lead-acid LV
WorkMode
48V
Range from 42 to 50V,
and the accuracy is 0.1V
Basic Parameter
Only display when
battery type is lead-acid
Only display when
battery type is lead-acid
Only display when
battery type is lead-acid
WorkMode
Rated voltage
WorkMode
240V
208V
To Next Page
Loading...
