When the grid frequency reaches 60+dbof, the inverter output active power is PM.
V
V
V
V
V
N
N
N
N
N
1.10 of
1.10 of
1.1 of 1.1
V
N
1.04 of
1.03 of
1.06 of
When the grid voltage exceeds V1, the output active power varies with the grid voltage.
Volt-Watt
Parameters
V1
V2
P1
P2
Delay time
Default Value
Minimum
Adjustable Range
Maximum
Adjustable Range
N/A
N/A
3s
0.5s 60s
Prated
Pmin
Pmin
(for Advanced Inverters
that can only inject
active power,Pmin
should approach 0)
(for active power output
at the time voltage
exceeds V1 in p.u. of
Prated)
(for Advanced Inverters
that can inject active
power)
Ppre-disturbance
1.7 Voltage-Watt (VW)
2 Remote control inverter on/off and modify parameter settings
The inverter have the following functions: Remote receive message from the utility or its
agent to start or shutdown inverter; Remote receive message form the utility or its agent
to complete parameter setting, enable or disable the above function in accordance to
Rule21.The remote control software: ShineBus can be obtained from the equipment
provider.
1.Confirm that the software
reads data normally
1) Please refer to 6.4.2 for
Shinebus electrical
connection.
2) Select the corresponding
communication port, baud
rate (default is 9600), and
the corresponding model
(SPH3~6K).
3) Click "start" in the lower
right corner, you can read
the data that the operating
software connection is
normal.
2.click“layout”and Choose
“UL”
3. In this page, can
activation the Rule21
function.
Setting the value in the
corresponding blank.
61
62
To Next Page
Loading...
