Growatt SPI 3000 - Parameters Setting

16
Parameters Setting
1. Work Mode Setting
The inverter includes three work modes: manual work mode, fully-automatic terminal work mode, GPRS
work mode (optional). The default mode is fully-automatic terminal work mode.
Click the back
key to enter the
main page
Click the
key
again to
set OK
Press the enter key
again Change the default
value of 1 to 0
Work mode
P00
Enter the main parameter
modification interface for long
press 2s for Enter key
Work mode
P00.01
Press Enter key ,to
enter view the P00.01
Work mode
0
0：manual mode
1：automatic mode
2：GPRS mode
Work mode
Set OK
Freq Run
50.00HZ