Grundfos CIM 500

English (GB)
2
English (GB) Functional profile and user manual
Original functional profile and user manual
This functional profile describes Grundfos EtherNet/IP for DDA
digital dosing pumps.
CONTENTS
Page
1. General information
1.1 Hazard statements
The symbols and hazard statements below may appear in
Grundfos installation and operating instructions, safety
instructions and service instructions.
The hazard statements are structured in the following way:
1.2 Notes
The symbols and notes below may appear in Grundfos
installation and operating instructions, safety instructions and
service instructions.
1. General information
2
1.1 Hazard statements
2
1.2 Notes
2
2. Introduction
3
2.1 About this functional profile
3
2.2 EDS file
3
2.3 Assumptions
3
2.4 Definitions and abbreviations
3
3. System description
4
4. Specifications
5
4.1 CIM module
5
4.2 CIM 500 Ethernet
5
4.3 EtherNet/IP
6
5. EtherNet/IP, CIM 500 setup
7
5.1 Connecting the Ethernet cable
7
5.2 Selection of Industrial Ethernet protocol
7
5.3 Setting the IP addresses
7
5.4 Establishing a connection to the webserver
8
5.5 Status LEDs
8
5.6 DATA and LINK LEDs
8
6. Detailed description of data parameters
9
6.1 Connection and assembly overview
9
6.2 Control parameters, output assembly 1
10
6.3 Other settings
13
6.4 Bus settings compared to the operating panel settings
14
6.5 Configuration parameters, Input/Output explicit
messaging
15
6.6 Dynamic status parameters, input assembly 2
16
6.7 Static status parameters, input assembly 3
21
6.8 Measured parameters, input assembly 4
21
6.9 Special parameters, input explicit messaging
22
7. Product simulation
22
8. Fault finding the product
23
8.1 EtherNet/IP
23
9. Disposing of the product
23
Read this document before installing the product.
Installation and operation must comply with local
regulations and accepted codes of good practice.
DANGER
Indicates a hazardous situation which, if not avoided,
will result in death or serious personal injury.
WARNING
Indicates a hazardous situation which, if not avoided,
could result in death or serious personal injury.
CAUTION
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate personal injury.
SIGNAL WORD
Description of hazard
Consequence of ignoring the warning.
- Action to avoid the hazard.
Observe these instructions for explosion-proof
products.
A blue or grey circle with a white graphical symbol
indicates that an action must be taken.
A red or grey circle with a diagonal bar, possibly with
a black graphical symbol, indicates that an action
must not be taken or must be stopped.
If these instructions are not observed, it may result in
malfunction or damage to the equipment.
Tips and advice that make the work easier.