Number Description Warning Alarm Alarm, trip lock
49 Speed limit ● - -
50 AMA calibration failed - ● -
51
AMA check U
nom
and I
nom
- ● -
52
AMA low I
nom
- ● -
53 AMA motor too large - ● -
54 AMA motor too small - ● -
55 AMA parameter out of range - ● -
56 AMA interrupted by user - ● -
57 AMA timeout - ● -
58 AMA internal fault ● ● -
59 Current limit ● - -
60 External interlock ● ● -
61 Feedback error (●) (●) -
62 Output frequency at maximum limit ● - -
64 Voltage limit ● - -
65 Control card overtemperature ● ● ●
66 Heat sink temperature low ● - -
67 Option configuration has changed - ● -
68 Safe stop activated (●)
(●)
4)
-
69 Power card temperature - ● ●
70 Illegal FC configuration - - ●
71 PTC 1 safe stop ● ● -
72 Dangerous failure ● ● ●
76 Power unit setup ● - -
77 Reduced power mode ● - -
79 Illegal power section configuration - ● -
80 Drive initialised to default value - ● -
81 CSIV corrupt - ● -
82 CSIV parameter error - ● -
90 Feedback monitor (●) (●) -
91 Analog input 54 wrong settings - - ●
92 No flow (●) (●) -
93 Dry pump (●) (●) -
94 End of curve (●) (●) -
95 Broken belt (●) (●) -
96 Start delayed (●) - -
97 Stop delayed (●) - -
98 Clock fault ● - -
99 Locked rotor - ● -
100 Derag limit fault - ● (●)
104 Mixing fan fault (●) (●) -
148 System temperature ● ● -
200 Fire mode (●) - -
201 Fire mode was active (●) - -
243 Brake IGBT ● ● -
244 Heat sink temperature ● ● ●
245 Heat sink sensor - ● ●
246 Power card supply - ● ●
247 Power card temperature - ● ●
24
English (US)
To Next Page
Loading...
