Number Description Warning Alarm Alarm, trip lock
248 Illegal power section configuration - ● ●
249 Temperature of the rectifier heat sink ● - -
250 New spare part - - ●
251 New type code - ● ●
274 The flow is not confirmed - ● -
275 Flow switch failure - ● -
2004 External fault - ● -
2007 Too high bearing temperature ● ●
2008 Too high bearing temperature ● ● -
2010 Setpoint signal outside range - ● -
2011 Sensor 1 is outside range - ● -
2012 Sensor 2 is outside range - ● -
2013 Temperature sensor 1 is outside range - ● -
2014 Temperature sensor 2 is outside range - ● -
2016 Limit 1 is exceeded ● ● -
2017 Limit 2 is exceeded ● ● -
4)
This warning or alarm cannot be auto reset via parameter selection.
(●) This warning or alarm is programmable. Warnings and alarms depend on the parameter settings.
25
English (US)
To Next Page
Loading...
