12 / 19
7. Fit the upper radial bearing pos. 205 carefully on the shaft with rotor and press it home in the recess of
the motor.
8. Apply a thin layer of grease to the O-ring pos. 224 and the lip seal ring pos. 232.
9. Tighten the top cover pos. 225 into the stator using the Ring insert tool 1) pos. N
and the To rq ue
wrench pos. J
.
Make sure that the cover is under the top of the motor, see Fig. 8.
, and that the axial play is between 0.3
and 1.3 mm.
10.Fill the motor with liquid, see section 4.5
Filling of motor liquid.
4.4.3 Analysing motors produced after week 5, 2006
1. Place the motor in a vice with the shaft end upwards.
2. Lubricate the thread of the motor with oil.
3. Screw the brass nut on the motor until the upper edge of the nut is flush with the top of the motor.
4. Fit the split cone, and tighten the screws.
Note: The split cone conical internally.
5. Tighten the nut against the split cone using the hook spanner (pos. I), and pull off the motor top.
6. Remove the motor top including the split cone when loose.
7. Unscrew the nut, and remove the motor from the vice.
8. Pour the motor liquid into a container. Make sure the rotor does not drop out.
TM032950 4905
Fig. 7. Motor shaft height
TM01 3136 0900
Fig. 8. Make sure that the cover is under the top of the motor
To Next Page
Loading...
