TM027008
TPD pumps without lifting eyes
Pumps with lifting eyes must be lifted by means of
nylon straps and shackles.
TM027009
TP pump with lifting eyes
TM027010
TPD pump with lifting eyes
4.2.2 Pipes
Fit isolating valves on either side of the pump to avoid
draining the system if the pump needs to be cleaned
or repaired.
The pump is suitable for pipeline mounting, provided
that the pipes are adequately supported either side of
the pump. TP 25-50, 25-80, 25-90, 32-50, 32-80,
32-90, 40-50, 40-80 and 40-90 are designed for
pipeline mounting only.
When installing the pipes, make sure that the pump
housing is not stressed by the pipes.
The inlet and outlet pipes must be of an adequate
size, taking the pump inlet pressure into account.
To avoid sediment buildup, do not fit the pump at the
lowest point of the system.
Install the pipes so that air pockets are avoided,
especially on the inlet side of the pump. See the
figure below.
12
English (GB)
To Next Page
Loading...
