Need help?Do you have a question about the Grundfos TPE3 and is the answer not in the manual?
General| Pump Type | Centrifugal |
|---|---|
| Motor Efficiency | IE5 |
| Power Supply | 3 x 380-500V, 50/60Hz |
| Communication | Modbus, BACnet |
| Control | Integrated frequency converter |
| Stages | Single-stage |
| Impeller Material | Stainless Steel |
| Enclosure Class | IP55 |
| Insulation Class | F |
| Series | TPE3 |
| Power Range | 0.75 kW to 22 kW |
| Speed | Variable speed |
| Connection Type | Flanged |
| Maximum Operating Pressure | 16 bar |
| Motor Type | Permanent Magnet Motor |
| Material | Cast Iron |
| Pressure Rating | PN 16 |
Describes radio module for remote control and external antenna requirements.
Provides safety warnings for lifting the pump, especially twin-head variants.
Details suitable liquids, warnings for hazardous liquids, and effect of viscosity.
Details the temperature range for pumped liquids and its effect on shaft seals.
Specifies ambient temperature limits for storage, transportation, and operation.
Details pipework requirements, valve placement, and avoiding air locks.
Provides instructions and safety warnings for fitting the pump head correctly.
Emphasizes grounding and protection against indirect contact, transients, and motor protection.
Covers single-phase and three-phase voltage, frequency, and connection.
Discusses ELCB/GFCI requirements and leakage current for motor protection.
Details terminal connections for advanced and standard functional modules.
Specifies requirements for signal and bus connection cables.
Emphasizes cleaning and flushing the pipe system before startup.
Details the process of filling and venting the pump before starting.
Step-by-step guide for starting the pump, including venting.
Explains how to set the desired setpoint using the standard control panel.
Example of setting setpoint for differential-pressure control with light fields.
Details how to start and stop the pump using the control panel buttons.
Outlines the pump's menu structure including Home, Status, Settings, and Assist.
Provides a detailed overview of menus available on the advanced control panel.
Explains how to set the setpoint for various control modes.
Lists and describes possible operating modes like Normal, Stop, Min., Max., Manual.
Lists and describes available control modes for the pump.
Describes communication types (radio, infrared) with Grundfos GO Remote.
Provides a menu overview for the Grundfos GO Remote application.
Recommended for heating systems with large pressure losses; optimizes energy and noise.
Combines AUTO ADAPT and FLOW LIMIT for systems needing a max flow limit.
Suitable for systems with large pressure losses or unknown duty points.
Explains the Constant pressure control mode and its requirement for external sensors.
Describes the Constant temperature control mode for domestic hot-water systems.
Explains Constant differential pressure control for systems with small pressure losses.
Explains Constant flow rate control requiring an external flow sensor.
Describes Constant level control using external level sensors for filling or emptying.
Details routine maintenance for the pump and motor.
Outlines conditions for returning the pump for service and potential costs.
Lists supply voltage and recommended fuse sizes for single-phase motors.
States leakage current values according to EN 61800-5-1.
Lists supply voltage and recommended fuse sizes for three-phase motors.
States leakage current values according to EN 61800-5-1.
Lists terminal types, thread sizes, and corresponding maximum torques.
Covers electrical codes for USA and Canada, CSA and UL standards.
Details FCC and IC compliance for radio communication in the USA.
Specifies conductor types, torques, line reactors, fuse size, and overload protection.
To Next Page
