Grundfos TPE3 - Advanced control panel; Menu structure

English (US)
20
13. Advanced control panel
This control panel is fitted as standard on TPE3 (D) pumps.
TPE2 (D) pumps can be fitted with the advanced control panel as
an option.
Fig. 32 Advanced control panel
13.1 Menu structure
The pump incorporates a startup guide which is started at the first
startup. After the startup guide, the four main menus will appear
in the display.
1. Home
This menu shows up to four user-defined parameters with
shortcuts or a graphical illustration of a Q/H performance curve.
2. Status
This menu shows the status of the pump and system as well as
warnings and alarms.
3. Settings
This menu gives access to all setting parameters. A detailed
setting of the pump can be made in this menu.
See section 15. Description of selected functions.
4. Assist
This menu enables assisted pump setup, provides a short
description of the control modes and offers fault advice.
See section 16. Assist.
TM05 4849 1013
Pos. Symbol Description
1
Grundfos Eye
Shows the operating status of the pump.
See section 21. Grundfos Eye for further
information.
2 - Graphical color display.
3 Goes one step back.
4
Navigates between main menus, displays and
digits.
When the menu is changed, the display will
always show the top display of the new menu.
Navigates between submenus.
Saves changed values, resets alarms and
expands the value field.
Enables communication with the Grundfos GO
Remote.
5
Makes the pump ready for operation/starts and
stops the pump.
Start:
If you press the button when the pump is
stopped, the pump will only start if no other
functions with higher priority have been
enabled. See section 20. Priority of settings.
Stop:
If you press the button when the pump is
running, the pump will always be stopped.
When you stop the pump via this button, the
"Stop" text next to the button will illuminate.
6 Goes to the "Home" menu.
1
2
3
4
5
6
Note
Note
You cannot make any settings in this menu.