25
English (US)
Settings TPE3 (D) TPE2 (D) Section Page
Setpoint ●●15.1 Setpoint 26
Operating mode ●●15.2 Operating mode 26
Control mode ●●15.4 Control mode 26
Date and time ●
1)
●
1)
Flow limit ● - 15.5 FLOWLIMIT 31
Automatic Night Setback ● - 15.6 Automatic Night Setback 31
Temperature influence ● - 15.15.3 Temperature influence 37
Buttons on product ●●15.19.3 Enable/disable settings 39
Controller ●●15.13 Controller settings 33
Operating range ●●15.14 Operating range 34
Ramps - ● 15.17.2 Ramps 38
Pump number ●●15.18.1 Pump number 38
Radio communication ●●15.18.2 Enable/disable radio communication 38
Analog input 1 ●●
15.7 Analog inputs 31Analog input 2 ●●
Analog input 3 ●
1)
●
1)
Pt100/1000 input 1 ●
1)
●
1)
15.8 Pt100/1000 inputs 31
Pt100/1000 input 2 ●
1)
●
1)
Digital input 1 ●●
15.9 Digital inputs 32
Digital input 2 ●
1)
●
1)
Digital in/output 3 ●●
15.10 Digital inputs/outputs 32
Digital in/output 4 ●
1)
●
1)
Predefined setpoint ●
1)
●
1)
15.15.2 Predefined setpoints 37
Analog output ●
1)
●
1)
15.12 Analog output 33
External setpoint funct. ●●15.15.1 External setpoint influence 35
Signal relay 1 ●●
15.11 Relay outputs 33
Signal relay 2 ●●
Limit 1 exceeded - ●
15.16.1 Limit-exceeded function 38
Limit 2 exceeded - ●
Standstill heating ●●
Motor bearing monitoring ●●
Service ●●
Store settings ●●
Recall settings ●●
Undo ●●
Pump name ●●
Unit configuration ●●
1)
Only available if an advanced functional module is fitted.
Alarms and warnings TPE3 (D) TPE2 (D)
Alarm log ●●
Warning log ●●
"Reset alarm" button ●●
Assist TPE3 (D) TPE2 (D)
Assisted pump setup ●●
Assisted fault advice ●●
Multipump setup ●●
To Next Page
Loading...
